top of page
PART 03  PCB PRINTED CIRCUIT BOARD

PART 03: PCB [PRINTED CIRCUIT BOARD]

BUILD HOPPER

  • Flip over the airframe and place the PCB as pictured below so it fits over the bottom of the airframe

  • There are [4] screw holes that will be used later on to attach the bottom body panel to the PCB and airframe

  • Note: You may find it helpful to install [2] screws to hold the PCB in place for the next step

  • Note: Please remove the red sticker on the camera lens when you finish your build




Airfoil

A body (such as an airplane wing or propeller blade) designed to provide a desired reaction force when in motion relative to the surrounding air

Airframe

The Airframe is the main body of the drone that every other component attaches to

Anti-Clockwise [A]

Anti-Clockwise (or Counter Clockwise) [A] motion is one that proceeds in the opposite direction as a clock's hands

Battery

Energy source used to supply power to the drone

Clockwise [C]

Clockwise [C] motion is one that proceeds in the same direction as a clock's hands

Firmware

Firmware is permanent software programmed into a read-only memory

Gimbal

The mechanism that allows for different position of the camera on the drone

Micro-USB

a miniaturized version of the Universal Serial Bus interface which enables the direct charging of the drone's battery

Motor

A motor is powered by electricity that supplies motive power for moving parts

PCB

A Printed Circuit Board is a board design with a base board and copper traces to maintain connectivity between electronic components such as LED's, integrated circuits, and resistors for your devices

Propeller Twist

A differece in angle between the blade at its tip, and at the point where it meets the propller hub

Propellers

Mechanical device for propelling an aircraft or boat, consisting of a revolving shaft with two or more broad, angled blades attached to it

INTRODUCTION

COMPONENTS

HOPPER BUILD OVERVIEW

PART 01: UNBOXING

PART 02: INSTALLING THE MOTORS

PART 03: PCB [PRINTED CIRCUIT BOARD]

PART 04: ATTACHING MOTORS TO PCB

PART 05: BODY PANELS

PART 06: PROPELLERS & PROP GUARDS

PART 07: BATTERY & BATTERY CHARGER

TROUBLESHOOTING

SIGN OUT

HOME

BUILD | FLY | CODE

ACTIVITIES

NEWS & UPDATES

Main Menu

Select an Option

home

build | fly | code

activities

news & updates

bottom of page