STEP 1: Feet Removal

• Gently peel back each of the [4] rubber feet attached to the airframe

• The feet are located directly beneath the motors

• Consider using the tweezers or screwdriver to help execute this step

STEP 2: Motor Removal

• Hold the airframe at the motor housing

• Use the motor tool to grip the motor

• Remove the motor from the housing by gently pulling and twisting simultaneously

• Repeat this step for all [4] motors

Caution: Be careful when removing the motors as to not damage the motor wires!

The Hopper Drone is now fully DISASSEMBLED.

After disassembly, your Drone Kit should have the following contents:

• [1] Airframe

• [1] Printed Circuit Board (PCB + Camera)

• [2] Sets of Propellers (2 A & 2 C)

• [2] Sets of Motors (2 A & 2 C)

• [2] Sets of Propeller Guards (4 pieces)

• [1] Set of Body Panels (4 pieces)

• [1] Set of Feet (4 pieces)

• [1] Set of Screws

• [1] T-3 Screwdriver

• [1] Pair of Tweezers

• [1] Propeller Tool

• [1] Motor Tool

• [1] Controller (2 AAA Batteries)

• [3] Batteries, Charger and Charging Cable