STEP 1: Feet Removal

Gently peel back each of the FOUR (4) rubber feet attached to the central body. The feet are located directly beneath the motors. Consider using the tweezers or screwdriver to help execute this step.

STEP 2: Motor Removal

Hold the Central Body at the motor housing, then use the motor tool the motor. Remove the motor from the housing by gently pulling and twisting simultaneously. Repeat this step for all FOUR motors.​

Caution: Be careful when removing the Motors as to not damage the Motor wire.

The Hopper Drone is now fully DISASSEMBLED.

After disassembly, your Drone Kit should have the following contents:

• 1 Central Body (or Airframe)

• 1 Printed Circuit Board (PCB + Camera)

• 1 Set of Propellers (2 A & 2 C)

• 1 Set of Motors (2 A & 2 C)

• 1 Set of Propeller Guards (4 pieces)

• 1 Set of Body Panels (4 pieces)

• 1 Set of Feet (4 pieces)

• 1 Set of Screws (16 - includes 1 extra)

• 1 T-3 Screwdriver

• 1 Pair of Tweezers

• 1 Propeller Tool

• 1 Motor Tool

• 1 Controller

• 1 Battery and Charging Cable